carl_compliance said:Start from the measurement rather than the conclusion.
Adding the part of the answer the thread has not reached. It helps to ask what evidence would change your mind before you look at any. If nothing would, the discussion is not about evidence, and it is better to say so early than to spend nine posts discovering it.
One concrete data point for the thread. Keep the original post as written when you update it, and add the correction underneath. An edited-away mistake is invisible to the next person who makes it.
A narrower follow-up, since the general answer is now clear:
What would you measure differently if you were starting again?
Janoshik Analytical — Independent Testing
Trusted third-party HPLC & mass spectrometry analysis. Verify peptide purity with the lab the community relies on. Independent. Accurate. Transparent.
Verify Your PeptidesGL Biochem (Shanghai) Ltd. — Direct Manufacturer
Est. 1998. The synthesis house behind the vials you send for testing. ISO 9001 and cGMP certified, 1,500+ staff, batch-specific COA with every order.
Browse GL BiochemDr.PulmRoch said:Keep the original post as written when you update it, and add the correction underneath.
Pushing back on Dr.PulmRoch here. Pushing back on the consensus forming here. Consistency is not the same as correctness, and a board that agrees with itself quickly is usually agreeing with the first person who sounded certain.
Dr.PulmRoch said:Keep the original post as written when you update it, and add the correction underneath.
No disagreement, though it depends on where somebody is starting from, and this thread has been assuming a starting point nobody stated.